Rear axle oil seal.

[LarryC1958]

Can anyone tell me the part number for my Farmall Cub rear axle seal on left side of transmission? It appears be 1.1" shaft and 1.75" outside diameter.

Serial # 205314

Thanks

 

[staninlowerAL]

Can anyone tell me the part number for my Farmall Cub rear axle seal on left side of transmission? It appears be 1.1" shaft and 1.75" outside diameter.

Serial # 205314

Thanks

This might be helpful. Stan

 

[Glen]

Hi,
Below is a listing at TM Tractor Parts for a new seal, you can look at the pictures.
https://www.tmtractor.com/new/df/245fp.htm

If you have the final drive off the Cub, I suggest you replace the other seal on the upper shaft, it is visible after removing the brake drum. It is in the final drive casting.
To remove it, remove the round cover held on with the 4 bolts, remove the brake drum, and brake drum key in the shaft, and the shaft slides out, away from the Cub. Then you can get to the seal, with a long punch, and hammer it out.
Don't hammer directly on a new seal, it can bend it. Oil the seal rubber, and the shaft where the seal runs, so they're not dry. Tighten the setscrew in the brake drum well. Maybe you knew this already.
Below is a listing for the oil seal for the final drive, it is bigger than the other seal.
https://www.tmtractor.com/new/df/044fp.htm

Below is a picture from TM Tractor Parts of where the seal is.