Zerk for 23 A disc

[Robert Cool]

Is there any place to get one of the zerks for the 23 A disc? I am missing one on the rear gang.

[Eugene]

Remove one zerk and take it to your nearest hardware store or auto parts store.

Your least expensive is to obtain a zerk kit off the internet. Then, needing a zerk, go to the kit.

Are you missing the tube that the zerk sits on? Again same as my first sentence, hardware store.

[Bob McCarty]

I remember a post where someone listed the parts they used to make one. Couldn't find it with a search though.
Edit: looked a different way: viewtopic.php?f=1&t=96489&p=760094#p760094
and viewtopic.php?f=1&t=96498

[Robert Cool]

Yeah the whole thing is missing, plugged with something cleaned it out so now just need to get one put in.

[Bob McCarty]

I just looked on Messick's website and they don't even show anything but the zerk itself. I'm guessing it's NLA new.

[tst]

the fitting should be 1/8" pipe thread, sis you also need the type with an extension on it?

[tmays]

They’re extended units. You might try JoeB. Last time I needed some, I got them from him. Good feller and knowledgeable.

[tst]

you can use a piece of 1/8" pipe nipple with a coupler on the end for the fitting

[Robert Cool]

Turns out the diameter for the zerk in question is roughly 3/8. The walls where it should be feel smooth so I am going to tap it and thread in a 3/8 to 1/8 bushing with new zerk.

[Eugene]

They sell zerks with 3/8" threads.

[Robert Cool]

That's good to know but I already picked up the bushings and zerks