Saturday fired up the 300 to pull out a shrub bush ran fine, sat for a couple hours put it away. No issues.
Went to start it up today, ran rough as hell, tried to let it run for a little bit didn't get any better, so shut it off. Would maybe act like it wanted to run for a little while but basically just sputtering. Tried starting it up later, wouldn't fire. Battery is good.
I have electronic ignition could something be wrong with that? It has ALWAYS fired up in the past, so this is very strange.
Was going to pull the plugs, clean them, drain the carb. But not sure what happened between 5pm Saturday and 3pm Sunday that it quit running smoothly.
Any thoughts on issue?
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 5+ Years
- Posts: 824
- Joined: Sat May 07, 2016 5:13 pm
- Zip Code: 45380
- Tractors Owned: 1952 Cub w/ 184 motor (Kid)
12V with Petronix
IH 3160 Mower Deck
54 Leveling Blade
193 Plow
IH528 Trailer
Front/Rear Weights
1955 Farmall 300 (Clarence)
12V with Petronix
Woods L306 72"
1955 Farmall 100 (Thomas)
12V with Petronix
Woods L59 60"
A60 Leveling Blade
Front/Rear Weights - Circle of Safety: Y
- Location: Versailles, Ohio
Any thoughts on issue?
Shawn Agne
-
- Team Cub Mentor
- Posts: 20202
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Re: Any thoughts on issue?
Check for spark.
You kept the points and condenser?
You kept the points and condenser?
I have an excuse. CRS.
-
- Cub Star
- Posts: 139
- Joined: Sun Jan 08, 2023 12:45 pm
- Zip Code: 33596
- Tractors Owned: Super A Industrial
Farmall 100
Re: Any thoughts on issue?
I thought about converting the Super AV to electronic ignition, but after doing some research and hearing about the "failure" rate on them decided against it. So, yes they can fail.
-
- 5+ Years
- Posts: 824
- Joined: Sat May 07, 2016 5:13 pm
- Zip Code: 45380
- Tractors Owned: 1952 Cub w/ 184 motor (Kid)
12V with Petronix
IH 3160 Mower Deck
54 Leveling Blade
193 Plow
IH528 Trailer
Front/Rear Weights
1955 Farmall 300 (Clarence)
12V with Petronix
Woods L306 72"
1955 Farmall 100 (Thomas)
12V with Petronix
Woods L59 60"
A60 Leveling Blade
Front/Rear Weights - Circle of Safety: Y
- Location: Versailles, Ohio
Re: Any thoughts on issue?
Yeah I've had them fail before, when the power gets left on. What I'm thinking may have happened here. I checked and there is power going to the coil. Have an inline spark plug tester coming. That will let me know if I'm getting spark. I have the old coil, and the points and condenser are somewhere in the barn. Key word being "Somewhere in the barn". I have a new electronic kit coming.
Shawn Agne
-
- 5+ Years
- Posts: 824
- Joined: Sat May 07, 2016 5:13 pm
- Zip Code: 45380
- Tractors Owned: 1952 Cub w/ 184 motor (Kid)
12V with Petronix
IH 3160 Mower Deck
54 Leveling Blade
193 Plow
IH528 Trailer
Front/Rear Weights
1955 Farmall 300 (Clarence)
12V with Petronix
Woods L306 72"
1955 Farmall 100 (Thomas)
12V with Petronix
Woods L59 60"
A60 Leveling Blade
Front/Rear Weights - Circle of Safety: Y
- Location: Versailles, Ohio
Re: Any thoughts on issue?
Ok got my inline spark tester and there is spark going to all the plugs. I'm going to pull and clean them. See if that works, then if that doesn't I'll drain the carb and start thinking fuel issues.
Shawn Agne
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Interesting possible backfire issue
by pokitisme » Mon Jun 05, 2023 8:32 pm » in Farmall H, HV, Super H, 300 & 350 - 10
- 237
-
by KETCHAM
Mon Jun 19, 2023 2:13 pm
-
Return to “Farmall H, HV, Super H, 300 & 350”
Who is online
Users browsing this forum: No registered users and 0 guests