This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Somthing to watch for with 300s
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- ShawnAgne
- 5+ Years
- Posts: 846
- Joined: Sat May 07, 2016 5:13 pm
- Zip Code: 45380
- Tractors Owned: 1952 Cub w/ 184 motor (Kid)
12V with Petronix
IH 3160 Mower Deck
54 Leveling Blade
193 Plow
IH528 Trailer
Front/Rear Weights
1955 Farmall 300 (Clarence)
12V with Petronix
Woods L306 72"
1955 Farmall 100 (Thomas)
12V with Petronix
Woods L59 60"
A60 Leveling Blade
Front/Rear Weights - Circle of Safety: Y
- Location: Versailles, Ohio
Somthing to watch for with 300s
Was mowing today and noticed when I started it up was cutting in and out a little. Figured just hasn't warmed up. Right at the end of mowing it was cutting in and out bad, and finally died. FIgured it was a fuel blockage, it wasn't. What was happening is the nut that holds the ignition switch had loosened up a little and it was rotating counter clockwise causing the switch to short out. Tightened that up and all is well. Bottom line, make sure that nut stays tight.
Shawn Agne
Return to “Farmall H, HV, Super H, 300 & 350”
Who is online
Users browsing this forum: No registered users and 7 guests