While rebuilding the hydraulic piston assembly on my Grandpa's 1951 Cub, I ran into a problem. Removing the Regulator Valve Seat. After several different failures my cousin came up with this idea.
I purchased a Blackhawk 3/4" Deep Well Impact Socket at Carquest.
3/8" Drive Impact Set at Northern Tool
3/8" Pittsburgh Deep Well Impact Sockets at Harbor Freight
Individual sockets may be available as well.
I measured the width of the slots of the Regulator Valve Seat with small straight screwdriver. Then I transfered the measurements to the socket and using a bench grinder and some water to keep it cool, I ground it out to fit the valve seat. I finished up by deburring it with a file and some sand paper.
Here are a couple of pictures of the end result.
If anyone knows where to buy a tool like this, please let me know.
Time saving tips to keep your Cub running smooth
1 post • Page 1 of 1
- 10+ Years
- Posts: 42
- Joined: Thu May 17, 2007 8:53 pm
- Location: Wilkes County, North Carolina
- Similar Topics
- Last post
Hydraulic Pressure Regulator Valve Bushing Removal Attachment(s)
by lyle11 » Fri Nov 06, 2020 2:59 pm » in Farmall Cub
Fri Nov 06, 2020 2:59 pm
by Gary Dotson
Mon Oct 19, 2020 8:07 am
Fri Apr 02, 2021 8:33 am
by Dale Finch
Mon Nov 09, 2020 9:59 pm
Mon Mar 01, 2021 12:59 pm
Who is online
Users browsing this forum: No registered users and 0 guests