Wagner loader installation
Posted: Sat Jun 26, 2021 8:18 am
Finally getting cub 2 put back together after 4 years and plan to put a fast hitch and Wagner w1 loader on it. Both were purchased from someone who said they were mounted on the same tractor but with an upright exhaust.
1. What are the dimensions for the bracket that moves the under slung exhaust over and down? OR how far over and down is it moved? Once moved will it interfere with anything on the fast hitch?
2. Which hydraulic line goes to the bottom of the bypass block? ( think I know just want to be certain )
3. I want to give the tractor a good shake down before putting the loader on. Until then, what do I need to do with the holes where the hydraulic lines will go? I read a post I think said to put a jumper line between them to prevent dead heading the hydraulics. Guess I don’t understand the flow path of the bypass block if that is true— especially because my loader has two gate valves that if closed would do the same thing ( dead head the hydraulics to the loader )
Thanks
1. What are the dimensions for the bracket that moves the under slung exhaust over and down? OR how far over and down is it moved? Once moved will it interfere with anything on the fast hitch?
2. Which hydraulic line goes to the bottom of the bypass block? ( think I know just want to be certain )
3. I want to give the tractor a good shake down before putting the loader on. Until then, what do I need to do with the holes where the hydraulic lines will go? I read a post I think said to put a jumper line between them to prevent dead heading the hydraulics. Guess I don’t understand the flow path of the bypass block if that is true— especially because my loader has two gate valves that if closed would do the same thing ( dead head the hydraulics to the loader )
Thanks