Farmall Cub

So I got my c60 back from the machine shop 40 thou on the bore and 10 thou under on the crank, not bad. But I need bearings now and I’m trying to find the right ones, my rod casting number is 251246R1 but I don’t see that as an option online anywhere it’s always r11 or 13, what’s the deal?

Btw I measures across the flats on the width of the rod with my micrometer and it measures .8679” I only see two sizes of bearing and neither of them are even close to this size I know they’re supposed to be a bit narrower than the rod.

main bearings are all the same, the rod bearings have two different types which are identified by the casting # of the connecting rod

251246R1 is the part number of the early style connecting rod. It is the rod ONLY. The same number with an R11, 12, or 13 is a minor assembly with the connecting rod as the major part. In this case, it is the rod, two bolts with nuts, and a piston pin bushing. The 10 under bearing for your rod is 376604R11.

Thanks guys

Jim Becker wrote:251246R1 is the part number of the early style connecting rod. It is the rod ONLY. The same number with an R11, 12, or 13 is a minor assembly with the connecting rod as the major part. In this case, it is the rod, two bolts with nuts, and a piston pin bushing. The 10 under bearing for your rod is 376604R11.

So would my rods be the equivalent of the r11?

yes early rod, uses the wider bearings, here are a couple part #s for federal and clevite Fp-1455 CB 310

Ok thanks