Looking for hydraulic by-pass block gaskets

[Filbert]

Good evening, I am new to the forum and thank you for such a great source of information!

I recently purchased a henderson loader for my cub and it came with a by-pass block, but I will need gaskets. I was wondering if it is possible to purchase the gasket for in between the by-pass block and the T/C unit (gasket B).

I attempted a search but had no luck. Thank you in advance.

[Dale Finch]

I haven't used a bypass, but I THINK I have read here that it takes the same gasket as the manifold. This is from TM Tractors, a forum sponsor:
http://www.tmtractor.com/new/hy/310fp.htm

BTW, if you completely remove the manifold to put the bypass on, you would need 2 of those gaskets, plus (perhaps) the 2 o-rings at the pump end of the manifold.
http://www.tmtractor.com/new/hy/751fp.htm

[Dadsfarmalls]

Filbert - Welcome to the forums! Not sure if these are helpful to you but heres an older post that has .pdf Brochures/Manuals for Henderson Loaders.

http://www.farmallcub.com/phpBB2/viewtopic.php?t=85678

Also here is a link to TM Tractors that shows a replacement hydraulic by pass block. Not sure what yours looks like but if it is the same as this then Dale has you going in the right direction.

http://www.tmtractor.com/new/hy/012fp.htm

[tst]

they are the same as the hydraulic lines