What does this belt pulley fit?

P

Peter C

New member
Hi, does anyone have an idea of what this fits on? It's 14 inch diameter with a 4 1/8 inch center hole and mount holes spaced 3 3/4 inches around the center.
Letters say Rockwood and This side out.

belt pulley, red.jpg

Thanks
Pete
 
I know that different sizes were available but I don’t think I’ve seen an H with one that large. F-12 had a pretty large one.
 
I could be wrong, but I recall the H/M pulleys having a large offset. If you tried to put this one on, it might run into the transmission housing.
 
Thank you for the replies. As far as the offsets goes the hub is centered and 3 1/4 inches in from each side.
Pete
 
Bear in mind, during the early days of mechanization, most industrial machinery was driven from a central power source through a system of jack shafts, pulleys and belts. This pulley may not necessarily be from a tractor.
 
Yes, I hadn't thought of that. I just saw the red paint and thought of tractors. I'm only familiar with Cub tractors.
Thanks
Pete
 
You must log in or register to reply here.
Back
Top