Welding indoors

BigBill

501 Club
If your doing a lot of welding indoors its good to use the special paint on the walls to prevent the welding reflection coming back at you. I have special non gloss paint for this ultra violet welding rays it actually absorbs it rather than reflect it.

Remember safety first.
 
One of the most painfull flash burns I ever had was to the back of my ears. I was welding inside a stainless steel tank trailer and didn't think about the reflection.
 
Thanks Bill

That's good to know. I have been trying to clean up my garage so I can get some work done this winter.

Billy
 
I did retain some stuff from welding school. When we built my new shop at work they were surprised i knew about this when we meet with the designers about my welding shop. Since i had all 500amp welding machines i figured i'm at a greater risk welding larger heavier channel and i beams for bed plates in one spot on two large acorn tables (5' x 8' each 28" apart). I did find the burns from the 500amp MIG and TIG to be the worst. We need the leathers too.

Its the ultra violet light that we don't actually see while welding that can reflect and get us again from behind. Its the 8 hours + a day being in this light that gets us.

BTW; The paint should be a lot higher on the walls so it won't reflect. We painted the block walls and the building steel and the floors too.
 
Back
Top