welding cast iron

freebird

Well-known member
I found a small antique cast iron "loveseat" with a leg that needs welded back on. What type of rod should one use? Any special methods? I tried to weld it with regular rod and boy it didn't do well.
 
Everything I ever heard was pre heat to 400 600 Degrees and cool slowly to stress releive. The V out and drill part was the same.

I will run this past my neighbor Al who is a steam fitter and does a lot of welding.
Bill
 
If you want to weld without preheating, use a cast rod, and only weld about 1/4 inch, and let cool, then weld agian, let cool, etc. Also rela old cast iron is frequently brittle.
 
thanks fellas I went by a welding shop and the old guy recommended the brass...and heating the whole area, keeping it hot. All good input so we will experiment with all suggested methods.
 
Back
Top