Vintage power hacksaw

Brent

501 Club
:( :( :( :x :x :x

I bought a vintage Sears power hacksaw and stand at a local tractor show and spent about 30 hours hooking it up to a Maytag hit and miss engine. I finally finished it the other day. I started it up yesterday engaged the clutch and the drop arm that holds the blade flipped back so hard it broke it and the drive link from the drive gear to the saw arm. I took it apart and on the drive gear, under all the muck, was a direction arrow. I had it running clockwise rather than counter clockwise. By doing so it was pulling up on the arm instead of pushing down. It was manufactured by Covel for Sears. Model # is 108-1502 mid-40's to early 50's. Does any one know where I might be able to get replacement parts? The broken parts are cast iron. I found a guy that says he can weld them back together but I didn't think cast could be welded. We'll see. Any advice.
 
Brent - the cast can be welded if done properly. I would consider checking with a reputable welder and try to repair it while you are looking for replacement parts. It beats just letting it set around while waiting.
 
Bigdog,
Found a welder that specializes in cast. Says there shouldn't be a problem. Also said that the older the cast iron is the better it takes a weld.
 
Back
Top