Troubleshooting Chevy S10-Torque Converter?

Thackery

Well-known member
Our farm truck a 2000 S10 is experiencing problems with the drive train.
I figured I would throw out the symptoms here and see what you guys think.
I am not a transmission or torque converter guy at all.
I don't use this truck much but have had it since 2001, just use it around here to haul wood, dirt, lumber, etc.
Symptoms:
When in drive or reverse it seems sluggish and needs a lot of rpms' to move, or at least more than I remember.
When you sit in neutral or park it does not always have the same amount of grab when you shift to drive or reverse. This is just sitting with the brake on.
I have had a small oil leak, I think from the rear engine seal for some time, it is small but you can smell it burning off after everything heats up.
The problem is intermittent, but has much higher frequency now than before.

What troubleshooting can I do to narrow this down to a specific problem?

This truck runs well otherwise but has over 200K on it and is not worth putting a lot into, however, the work I get out of it is worth a lot, so, that's my story.
I appreciate any opinions, questions, comments, etc.

Thanks, Thackery
 
Thackery":3rwn8fc7 said:
Our farm truck a 2000 S10 is experiencing problems with the drive train.
This truck runs well otherwise but has over 200K on it and is not worth putting a lot into, however, the work I get out of it is worth a lot.
Take the pickup to the local GM dealership and have them analyze the problem and provide a repair estimate.

You will have to make a decision. In this part of Central Missouri, used pickups are at a premium. It's almost cheaper to buy a new pickup than a used one.

Recently spent more money for two new front tires on the Ford F250, farm truck, than the pickup was worth. Decision time. Two front tires were cheaper than another pickup.
 
Definitely not an expert, but your symptoms seem to cover a wide area. Worn clutches, plugged filter, low or dirty oil, dirty/sticky valve body, etc. As Eugene said, it needs to go to someone who knows shat they are doing.
 
Several months ago I followed my son as he drove a 2003 Dodge Dakota with around 240K miles on it to the scrap yard. Not sure what son received for the scrap value, guessing around $300-.

Decisions, decisions, decisions.
 
Hi Doug;
Is the fluid level up to the proper mark on the dip stick? What color is the fluid? What does the fluid smell like? Brown stinky fluid points to likely expensive problems. Low fluid level could easily cause the symptoms you describe. At any rate, it's not likely a torque converter problem, but a transmission problem. A fluid & filter change might help, but probably not. My guess is that you're experiencing clutch failure.

I'm sure you are aware that having your transmission rebuilt by a transmission shop or installing a rebuilt unit is going to cost way too much. You might consider a used one, but that's a bit risky, be very careful who you deal with. I've gotten pretty rusty on trans rebuild, but I've done a few of those 4L60E's in the past. There are a few inherent problems that show up from time to time.
 
Thackery,
I have a 2002 Chevy Astro AWD van. At 100,000 we had the 4160e tranny rebuilt. We now have 204,000 miles on it.
1) Sun Shell was just about ready to fail. When it goes you lose reverse and overdrive. OEM Sun Shells for a few model years in the 1999 to 2002 years are notorious for failing. Replacement units have beefed up design in critical areas.
2) Pump was leaking badly. It's two cast aluminum halves had warped enough to allow transmission fluid to leak out at a pretty good rate such that the underside of the van was coated up. Lose too much fluid and things don't work the way they are supposed to.
My guess is if you've never had any work done on the tranny, one or both of the above is going on. Figure $2k for a good rebuild.

Peter
 
Ok, so I checked the fluid level again, this time cold (above the mark for cold) and idle hot (below the hatch marks). Well looks like I will add some fluid and see what happens. I guess I checked cold before and moved on. The fluid on the stick when I first checked was both dirty and a bit of a not good smell, after running it, it did not look bad. I will check again after it sits and cools.
Eugene, lets try to be optimistic and avoid the "how to scrap the truck" for now.
I checked the odometer, actually has 204820 on it. This is my 2nd S10, both driven until they couldn't go any more.
This one has seen so many loads of wood, mulch, dirt, trash, scrap, etc. I think it has been to Barnyard's 3-4 times, Bigdog's, and Gene's, etc.
I hate to put a bullet in it just yet. It will not be getting several thousand dollars of repairs.

Thanks for help.

Thackery
 
Thackery":3rhz89nm said:
Eugene, lets try to be optimistic and avoid the "how to scrap the truck" for now.
Decisions, decisions, decisions.

Our Ford F250 is on it's last legs. Floor boards rusted out, bed is beat up beyond believability, but still passed inspection. Use the pickup about once a month to haul fire wood and move machinery. Truck is at the point that another dent, crunch, crash, isn't going to hurt anything.

Told my son that he could have my 2005, 1500 Dodge Ram, 136K miles, as a work truck. Son said that the Dodge was in too good of condition be utilized as a farm work truck.
 
Doug, if you check your fluid level cold and not running, it will always register high. You should always check it warmed up, running and with the selector in neutral. Shift the transmission through all selector positions, pausing a few seconds in each position then returning to neutral. The fluid level should register in the safe zone. It sounds like you may just be low on fluid. Keep in mind, however, continued running with low fluid level will lead to serious damage.
 
Back
Top