Special Taps & Dies

birddog

501 Club
I bought this set off e-bay and figure they must be for a specific application, but what. There are a couple pieces missing and and it looks to be a couple of the pieces were from a different set.

They have no size markings in inch nor metric, but are marked from 0 - 3. (4 sizes) The taps and dies and cutters only have the number on them. The drills are marked as Peg 0 - 3 and Screw 0 - 3. The ones marked Screw are smaller diameter then the Pegs.

Also it looks like there would need to be a couple special drive tools which aren't a part of the set. In the picture you can see the slot on the side of the dies that I would guess that a drive tool would lock into. On the drills and cutters there is a pin sticking out the side. You could use a power drill the way the drills are but I would think they were made for a special tool of some sort.

normal_IM000739.JPG


normal_IM000740.JPG


normal_IM000743.JPG
 
Sorry, I had meant to get some measurements before I posted but forgot to.

There are no markings on the box except what you can see in the pictures were it's marked for placement. No patent numbers or anything. On closer inspection today (in the light of day) two of the chrome die holders are stamped with PGH. The two non chrome die holders and the odd cutter have a P stamped in them.

Here are the sizes they appear to be.

0 - 6-32, A 6-32 screw is a little loose in the die so It may be a different size. Possibly 7-32? (an 8-32 is to big)
1 - 1/4-20 Screw 1 7/64 or #38
2 - 3/8-16 Screw 2 5/16 or #N PEG 2 23/64 or T
3 - 7/16-14 PEG 3 27/64

The cutters are about the same OD with the ID slightly larger then the corresponding PEG drill.
 
Well, I thought knowing the sizes might help. I was wrong on that. Maybe it will help someone else. Could they be for installing some type of dowel that is threaded on one end? Maybe a "1 peg" is the opposite end of a "1 screw". That leaves me with no idea what the cutters would have to do with it. Do the cutters fit in the big end of the dies? I don't have any idea why somebody would need such an assembly, but it may be a clue.

The British have had their own way of doing things (and different thread sizes). Maybe someone from over there would recognize it.
 
Jim; the cutters fit inside the die holders but not for the purpose of use. Only in that they are smaller in diameter.

Here is a better picture of the cutters.
The OD on the cutting face is 3/4 inch, OD on the small end is 5/8 inch.
normal_IM000744a.JPG


Forgot to add that the ID of the cutters is the same as the ID of the small end of the die holders.
 
Back
Top