Small portable generator

Bus Driver

501 Club
The 4400 watt "portable" generator is not easy to lug around and often the power requirements for a job are less than the 4400 watts. So one of the Harbor Freight 800watt/ 900 watt surge units made it's way to my shop some time ago, perhaps more than year. Chinese.
Gravity fuel feed, no priming bulb, just single fuel line. Out of the box acted like fuel did not seem to be getting to the carburetor. Few drops in the spark plug hole, pull one time and it runs like a champ- for a 2-cycle. Tested with various loads and it does extremely well.
Ran it until it stopped, assuming that the fuel tank was empty. Stored it with no further action.
Needed it this week and it ran briefly only when and while primed in the spark plug or carb intake.
Turns out that the tank retains about 2 ounces of fuel when the engine stops on it's own. Perfect setup for gum formation.
It is again running well. After it ran out of fuel this time, it was turned upside down to get rid of all the remaining fuel possible. Being a 2-stroke, there is no crankcase oil to spill when inverted.
Some sources indicate that this unit is a clone of a Yamaha unit that is/was made in China. Apparently many of the parts are interchangeable.
 
I ran into the same problem you did with my 6500 watt being to heavy to drag around, so I bought one of the little generators similar to yours, but after fighting it's being hard to start, not being big enough to run anything, etc. I got a different one.
http://www.amazon.com/gp/product/B0052L ... UTF8&psc=1
When I bought it in August 2012, it was about $265, not the $344 it is now, but they do frequently run them on sale for a better price than current. I keep Sta-bil in my gas and never empty it. If I don't start it for 3 or 4 months it may take 4 or 5 pulls to start, but it pulls easy, and if I start it every week or two, it seldom takes more than 1 or 2 pulls. The only bad thing is that it does weigh about 65 lbs, but I keep it strapped to a cheap folding dolly to move it around.
 
I solved the weight problem by mounting my 10 KW generator set on a 2 wheeled trailer. Two wheeled trailer makes it easy to move around the shop or to use a pickup or tractor to move to the job site.

I have a 4 KW gen set that I was able to pick up and install into or out of the back of a pickup. If the 4 KW gen set keeps gaining weight, plan is to purchase a low cost 2 wheeled trailer and mount the gen set.
 
Back
Top