Replacing carbon brushes in grinder

Paul_NJ

501 Club
I have an old B&D 4 1/2" angle grinder that has been a workhorse for 25 years. I've already replaced the bearings in it, but now the carbon brushes are gone. I've tried the online parts suppliers, but replacement brushes are no longer available for this model. I tried ordering the nearest available model number, thinking "I'd get lucky", but the new brushes are too wide for the brush holder. Does anyone have experience cutting down brushes to fit? I could do it on a sanding wheel. Considering the alternatives I guess I've got nothing to lose, but I wondered if others have done this.

Paul
 
Paul,
I have trimmed brushes to fit. A flat surface and sandpaper will work to fine tune things. Take your time and make sure you have a good fit. If they are too tight they won't feed well and if they're too loose they'll move around and wear quickly as well as have a tendancy to arc.
 
All the posts so far are correct. Carbon does sand down really fast, take your time, when you start to get close, check them often.
 
Agree with John. Local hardware store and autoparts store has plastic boxes with brush assortments. Usually they can match you up.

Since you have brushes on hand. Try sanding them down to size.
 
Back
Top