propane heater

john2189

501 Club
Does anyone use one of those propane heaters shaped like the kerosene torpedo heaters ?

Im using a kerosene torpedo now and its so loud you cant hear yourself think. Are the propane ones loud too ?


John
 
I do not have one myself, but have been around them when they were running, and the noise may be slightly less, but it is comparable. I assume the size and age may both make a difference. Per example, I have a 35+ year old Sear 85,000 btu Kerosene heater, and a 10 or 15 year old 55,000 btu kerosene Reddy Heater. The Reddy Heater makes about 1/2 to 1/3 the noise of the Sears, but you can set the Sears a lot further away and feel the heat blown to you than the Reddy Heater. Of course the Reddy Heater takes a lot less fuel, which I assume is due both to size and being more efficient due to age. One thing I have found is that though they were both originally recommended to use kerosene, the new low sulfur diesel runs just as clean, and is a lot cheaper.
 
I have a 125,000 BTU kerosene torpedo heater and really I thought the noise was OK. Although I bought mine last year so maybe the noise is going down. I'll tell you that heater sure comes in handy if I want to work out in the shop during the winter.

Jason
 
I have a barrel style propane heater that supplies only radiant heat. It is quiet but like most radiant heaters it is warm only near the heater.
 
josys36":2bpjtep3 said:
I have a 125,000 BTU kerosene torpedo heater and really I thought the noise was OK. Although I bought mine last year so maybe the noise is going down. I'll tell you that heater sure comes in handy if I want to work out in the shop during the winter.

Jason

I'm very interested in this thread, since it might be chilly down here in February. Any recommendations on the kerosene or propane heaters is much appreciated.
 
Now Roy, I'm not planning on making that trip just to have cold weather. You'd better order up some warm weather for us! :wink: :wink: :wink: :wink:
 
Bigdog":1gdg8ke6 said:
Now Roy, I'm not planning on making that trip just to have cold weather. You'd better order up some warm weather for us! :wink: :wink: :wink: :wink:

That is the plan, BD. I have placed multiple orders. Hopefully, they get delivered on the right days. :lol: :lol:
 
I have one of those Mr Heater 35,000 BTU propane Torpedo style heaters. Up here in -35C or lower, doesn't offer a ton of heat, but enough to keep frostbite away. Relatively quiet compared to the standard construction torpedo heater.. mostly cause the blowers are much smaller. Useful little critter.. course now with a bit of insulation, it might warm the barn a bit more.. :lol:

Not sure how useful they would be to keep it shirtsleeve temps.. probably need to go to one of those radiant heaters with a blower -- the type that hand from the ceiling etc... with a much larger BTU rating.
 
I have a big convection propane heater. It is not as loud as a salamder heater. Just as pain to refill the tanks especially on cold and really windy days.
 
I'm using a smaller propane square heater from TSC and it feels to bring up my 1 car garage about 10 t 15 degrees. Enough to work in for right now. My new 1 1/2 car garage will be insulated floor, walls and ceilings and woodstove heated. On my last garage i even put R15 insulated garage doors on it too. On the floor we put down the 1" foam then the clear plastic and poured 4" thick cement floor. Even the floor was warm with the wood stove. I can't wait to have my shop setup again.

I only use the top loader woodstoves like the Tempwood because of gas fumes that are on the shop/garage floor roughly 4" off the floor. When i work with any type of gasoline i don't light the woodstove during that time anyway to besafe. But if you park a tractor or car in the garage we do have gas fumes 4" off the floor anyway. Its good to open the garage door first to get the fumes out before welding in it.
 
Back
Top