Powering a winch on a car trailer?

Jim Becker":rckorlaz said:
Lt.Mike":rckorlaz said:
. . . is your tow vehicle already wired for electric brakes with a 7 pin hitch ? If so there is a pin which I believe is the center that is a constant 12v Power source. . . .
I doubt that wire would be heavy enough for the current draw of a winch, even a fairly small one.
There are two 12v power leads fed by the fuse block besides that which power lamps. One is for electric brakes and the other a constant 12v power source. Both of those have a 10 or at least 12 gauge wire. That’s more than enough to power a winch.
If you bought a vehicle with a “tow package” even if it didn’t come with a brake controller installed if you open up the loom jacketing in the rear where it runs rearward from the fuse box under the hood you’ll find 2 lengths of 10 gauge wire with about 18” worth folded back along its length for this purpose. Both my Chevy K1500 and Jeep Commander had it from the factory.
Edit: the center pin is actually the back up lamps.
I’ll try to attach a diagram...
ok it’s #4 you want for positive and #2 for negative. On the fuse block end there will already be a relay circuit breaker.
7-Way-RV-Style-Trailer-Plug-Wiring-Diagram-1.png

faq311-7-way-trailer-diagram_2_1000.jpg
 
That 10g wire is going to be 20 feet long, maybe more by the time it gets to the winch. That says it is good for maybe 30 amps. Lets be generous and say 50 amps. I don't know how big the circuit breaker is that feeds this wire. But I'm pretty sure nothing in my truck is more than 50 amps. A quick look at Warn's web site lists a 2,000# winch with this spec: "MAX AMP DRAW/ LINE PULL 80 Amp Draw/ 2000 Pound". So we're already in trouble. The original poster was talking about a 12,000 winch (469 Amp Draw/ 12000 Pound).

My truck came with a connector under the dash for plugging in the brake controller. All you needed to do was buy the little harness that matched the truck brand.

In the trailer connector, #2 is for the brakes. The ground is #1.
 
Best if you have a on-board deep cycle battery on your trailer.

The +12v on your trailer plug will help your on-trailer battery if you run the tow vehicle while winching!
 
SamsFarm":2camvv8f said:
Best if you have a on-board deep cycle battery on your trailer.

The +12v on your trailer plug will help your on-trailer battery if you run the tow vehicle while winching!

This is how I would do it. The same way my tow vehicle keeps the 12v battery on my travel trailer charged. When running the winch, the onboard battery will supply the juice. And only a little current will flow to the onboard battery through your 7 pin plug unless you completely deplete the onboard battery.
 
Back
Top