Portable generator not producing current

Zorro

Well-known member
Anybody ever have any luck with this problem? I have seen different remedies on the internet, but none have worked. The generator is a small, suitcase type, and only 750 watts. Anyway, I understand the bit about them losing their resident magnetism, but nothing I have tried so far works.
 
If you are following the instructions about using a drill to flash it, it has to be a standard drill that is not variable speed. As a stupid question, have you checked the circuit breaker?
 
John *.?-!.* cub owner":38epbzzu said:
If you are following the instructions about using a drill to flash it, it has to be a standard drill that is not variable speed. As a stupid question, have you checked the circuit breaker?


The drill I tried was not variable speed, but I didn't know about that requirement at the time. It was one of my smaller drills though, so perhaps it could not produce enough current to make it work. I have a bigger drill to try.
The breaker is not popped, but I suppose I could test it with a multimeter.
Thanks,
Paul
 
Make and model of the generator set? Wiring diagram for the generator set?

One of my gen sets quit working. The problem turned out to be a crimp connection on one of the wires to the control panel. Took a while to trace out the problem. Easy fix.
 
size of the drill is not important, it takes only a very small amount of current/voltage to begin building magnetism. On modern generators it is rare to have that problem. Is this one of the inverter generators?
 
No, it's not an inverter generator. I'll try the drill thing again, and if that fails, I'll start taking it apart and checking things. I have no diagram or manual for it, but I know I could come up with one if needed. I really think it must be a loss of magnetism because it worked before it sat for a couple of years.
Thanks,
Paul
 
Back
Top