Parts Cleaning Solvent

Paul_NJ

501 Club
I picked up a used parts cleaning unit today. I thought it might be a big improvement over my usual technique of soaking and scrubbing parts in an oil change pan with kerosene, and then fishing them out by hand. It has an external pump, filter screen, and a solvent tank, and has a Safety-Kleen solvent emblem inside. I went to the Safety Kleen website and see that you can mail order their solvent for $53 for 5 gallons. Geeze, that's 2-3 times the price of kerosene!

I assume such solvents are less flammable than kerosene. Does anyone have experience using one of these with kerosene? It sounds unsafe but I don't know for sure. Is there is a generic, and less costly cleaner I can use than the Safety-Kleen stuff?

Thanks
 
I use the Tractor Supply solvent, but it is not cheap either $35 per 5 gallon .can.

3893915.jpg


Kerosene is up to 4.25 per gallon here.
 
I have 2 tanks, both have had K-1 in them for the last 4 years or so. Just keep the lid closed whenever possible and make sure you have a working fusable link.
 
I work for my local township. We have to sit through many training classes every year. Kersosene, diesel, and gas are known to cause cancer. they are not allowed to be used in the solvent tanks. I imagine in a few years the expensive solvent will be removed because it causes cancer.
 
I bought a 5 gal. Safety Kleen unit 10 yrs ago from them. It had new solvent in it then and today it has the same solvent still doing a heck of a parts washing job.. I think my solvent is non-flammable but Ive never tested it (Thank God). Frank
 
I'd place my vote for getting the Tractor Supply Parts Cleaner.

I think it's formulated for a very high flash point just like the expensive stuff, and for the lower price, why not keep it safe while you save some dough?

I also shy away from kerosene and other cheaper stuff because of the reputation for higher risk of causing cancer.

Just my .02

Corky
 
I use Varsol. It is cheap, good, relatively safe in a well ventilated area and does not evaporate all that quickly. There are others out there, Kero is good, some of those "Green" products are ok, but I find for the money Varsol is about the best. I have used it for over 40 years and I am very happy with it. A quick wipe with lacquer thinners after and poof.. all neutralized.

Keep the lid on it though, always best to keep safety first.

Oh, I had a 20 gallon barrel of that Safety Kleen stuff... operative word had... it is gone now.. thankfully. Was a PITB.. got thick and gooey and useless.
 
A little trick I have learned to extend the life of my cleaner solvent. I wait for a time when I am not going to be using it for 2 or 3 weeks ( a little difficult for some of you, I realize) and after it has set for a couple weeks or more so that most of the dirt has gone to the bottom, I take a small hose and prop it so the end is about an inch off the bottom of the tank, then slowly siphon the upper fluid out. after it is out I dump the remaining dirty fluid into a container, and pour it over some brush, etc that I want to burn and light it. When I refill I top it off with some fresh fluid, sometimes using kerosene that has gotten so old it does not work good in a heater, but mostly I use the TSC solvent I posted earlier.
 
I use mineral oil from napa.I used to[still do] get a discount from them.A good parts cleaner is the way to go!!!!Kevin :D :D
 
Back
Top