I have an old “Vanadium Steel” 70 lb anvil that I want to clean up and sell. From what I read about them they were manufactured in the late 30s-early 40s and sold by Sears and Monkey Wards. It is in good condition and been always been stored inside but has surface rust and most of the paint is gone. I was planning to remove the rust and remaining paint with a wire wheel and then would like to coat it with linseed oil or some rust preventative to shine it up a little, prevent rust, and make it more appealing to a buyer.
I was wondering if anybody has any ideas about what I should use to coat the metal. I have no use for the anvil and plan to sell it but I’ve read linseed oil may yellow and crack over time and is hard to remove.
I was wondering if anybody has any ideas about what I should use to coat the metal. I have no use for the anvil and plan to sell it but I’ve read linseed oil may yellow and crack over time and is hard to remove.




