Magneto charging

Jeff Silvey

501 Club
I have a mag charger that charges a wico, webster mags on old engines. I have recharged some through for years.
My question can I recharge a J4 plus a H4 mag coils? Some members know what I have on charger. I have had this unit for 20+ years.
Thanks
 
Possibly an H4, but the J4 has a magnetized armature. While I'm sure there is a machine somewhere that could re-magnetize one, most older machines likely would not. And yes, it's the magnets that get magnetized, not the coil. I have personally run across two J4 magnets where the armature had lost its magnetic attraction. They are called "permanent" magnets meaning they weren't expected to need re-magnetizing over time; however, if stored incorrectly or placed near an electrical or magnetic source, it would be possible to damage one. Those armatures were made from "alnico", which is considered a permanent magnet, since the magnetic attraction comes from the crystal alignment, and not from an outside source such as your magnetizer.
 
Rick, electronics is my field of work, and the biggest danger to a permanent magnet is storing it close to a large transformer. The magnetic field it creates is quite sufficient to demagnetize even a strong magnet like the J4 armature.
 
Rick, electronics is my field of work, and the biggest danger to a permanent magnet is storing it close to a large transformer. The magnetic field it creates is quite sufficient to demagnetize even a strong magnet like the J4 armature.
I know this post is 5 years old, but I am currently researching this and came across this thread. I have tried before to convert my external coil back to magneto without success. Johns statement has made me realize something. When I bought this tractor it had an external coil mounted right beside the magneto, and I have since mounted it on top of the magneto, having installed a flat plate over the magneto in place of the mag coil cover and mounting the external coil on top of it, putting it in very close proximity to the rotor magnets. I am assuming the external coil, which is basically a transformer has demagnetized the rotor magnets, which may be my issue. It's all theory however without testing. Any idea how one would test the rotor magnets on a J4?
 
If I remember correctly, rotate the mag backwards by hand and you should feel a resistance. It happens in forward direction too of course but you won’t feel it since you have to overcome resistance from the impulse. Send Rick Spivey a message. He can set you straight on that. But again, if I recall correctly, and your armature has demagnetized, he does not know anyone who does that.

Edit: you’d be better off starting a new thread on this in the Cub forum. More people would see it
 
Last edited:
Back
Top