High RPM C

H

Hickup

Active member
Its been a while but I'm back to the toys.... Finally got my c running. I drove it around and I couldn't get the throtle up. Now I cant get it to stop from over idleing. I push and pull the idle lever and it doesnt budge. I end up shutting it down so I don't hurt the engine. Whats up? I could use some help... Thanks
 
Sounds like the governor or linkage is sticking. I'd start by checking all the linkage for movement and look for things like a broken spring etc.
 
I think I would spend some time studying a manual or technical guide on the the governor. High speed RPM and idle are both critical settings on the governor, not the carb. Good luck.
 
Well, I'm back again!!!! I miss this site and playing with my toys. Thanks for the advise Bigdog. I did check every likage. I finally got it back. I rebuilt the carb AGAIN.... That was the problem for the high idle. The float wasnt slowing the gas down. But now its great. Looking forward to reading and helping everyone I can.

Marc
 
You must log in or register to reply here.
Back
Top