Geometry Help

Dusty B

501 Club
Not really a cub question but has been too long since my math training! Have a chord 52" long, want a 4" rise @ midpoint (26") what radius do I use to get that? Thanks to someone sharper than I ! Dusty B
 
I came up with 86.5 inches by typing this into google:
26/(sin(2((pi/2)-arctan (6.5))))

Eugene's page comes up with the same number, so I guess it is probably right.
 
Thanks guys - I'll give that a try! - actually it is the curvature above the windshield in my '55 Dodge pickup that I'm putting a new headliner in - I'm making a pattern so it is right as I only have enuf material for one go, so it needs to be right the first time! I'm doing an upholstery class at the local Jr. Coll and am going to try to do a FANCY cub seat - w/post pics if I pull it off! Thanks again, Dusty B
 
I once had a 55 Dodge pickup. The headliner was a paperboard product as best I remember. It received no special attention while I owned the truck.
 
Yes, I am doing a pattern first, the paperboard in this one was shot! Replacing it w/shower liner (plastic - flexible) w/vinyl glued to it? Too cheap to buy new paperboard kit @ $150 and wanted something a little dressier. Check out my seats on "other projects" - proud of a beginners effort on those! LOL !! Dusty B
 
Dusty,

As I understand the "?" Chord = 52"
external (rise) = 4"
Radius = 86.5"
cord length from either left or right quadrant to intercept of designed cord = 8' - 6.306"
As plotted out with AutoCadd.
 
Back
Top