Farmall Cub Fan Hub Assembly

R

RunningRed

Well-known member
Hey guys I just wanted to make another post separate from the radiator one so it doesn't get too off topic on that post. I got the fan hub assembly off but I have no idea if this is the new style or old style? I cleaned it up to reveal a few numbers. When I spin the shaft I can feel something in there like grit or a bad bearing. I did oil the hub assembly when I bought it and the oil coming out looks good. I tried to upload a picture but it just keeps saying the file is too large.
 
I got the fan assembly all disassembled. There isn't much to it but I can't remake the shaft or the flange looking thing that the shaft slides into. There doesn't seem to be more than .005 of wear so I am going to just leave it be as is. I do however need another gasket for it. Again I tried to take a picture and it keeps saying it to large.
 
RunningRed said:
I got the fan hub assembly off but I have no idea if this is the new style or old style?
Click to expand...
If it is like the owner's manual, and parts manual show, it is the IH fan hub assembly.
The replacement assembly with sealed bearings has no oil fill screw on the side of the hub.
TM Tractor Parts has a new fan hub gasket.
 
Last edited:
Glen said:
If it is like the owner's manual, and parts manual show, it is the IH fan hub assembly.
The replacement assembly with sealed bearings has no oil fill screw on the side of the hub.
TM Tractor Parts has a new fan hub gasket.
Click to expand...
I seen doing some research that there are 2 gaskets. Mine was completely missing the other 1.
 
You must log in or register to reply here.
Back
Top