Duramax DEF question

Trent M":21n7pphx said:
Have you tried a dedicated Duramax diesel or Chevy truck forum? There are folks out there with seriously deep knowledge of almost everything, just like some of the folks here on FarmallCub.com!!
Trent, after talking to the service rep at GM (not the dealer) I am very confident the truck will be fine. Since I found out we had a heater problem I have driven over 1,000 miles. If the DEF was not getting to the exhaust by now, it would have shut me down or at least the speed reduction would have kicked in. As it appears, the heater would not come into play unless we encounter temps below 12 degrees along the way and as long as we don't get those temps the DEF will flow.
 
Don McCombs":262z08ne said:
If it gets below 12 degrees here, I'm going to Cuba. :D
I got it figured this way, according to the manual, the speed reduction does not activate until 1,000 miles after the sensors say there is no fluid. So if it is zero here, the warning will tell me I have 1,000 miles before I have a top speed of 65 mph. By time I get to Alabama (400 miles) the fluid would be thawed enough to flow. Therefore the sensors would then reset.
 
Barnyard":3kr7fgtp said:
Jim Becker":3kr7fgtp said:
Steve Butram":3kr7fgtp said:
I have been immersed in the Exhaust regeneration systems since 2013. . . .
!!!
And he can't get out!

I got very educated in Diesel Exhaust, Particulate and DEF systems When the EPA decided that all Fire Apparatus built after 2010 were to be fitted with Particulate regeneration systems. My experiences have varied. I No longer have to upgrade the apparatus with NO SMOKE particulate Filters. The issue I have been dealing with lately is someone introduced DEF to the Diesel tank, 5 gallons the best we can tell. The truck started showing a water alarm in the fuel system. We kept samples of the liquid drained out and figured out it was DEF that was mixed with the Diesel. The fuel tank had to be drained and cleaned out.That could possible be a $30,000 mistake. And as you would expect no on knows how it got in the diesel fuel.

Another issue is the operators have a Regen inhibit switch available on the dash.They have been successful in defeating it enough times to have to take the truck to the Dealer to force a Regen cycle.

"I should have wrote Educated"
 
Steve don't that regeneration inhibit switch also have a start regeneration mode. First instruction we were given was if you inhibit regeneration you MUST start a cycle as soon as clear to do so. If you didn't and a dealer forced reGen was required you and Director of Fleet maintenance have a talk about how you want to pay the bill.
 
Rabbit Holler Flash":3m1fsuj1 said:
Steve don't that regeneration inhibit switch also have a start regeneration mode. First instruction we were given was if you inhibit regeneration you MUST start a cycle as soon as clear to do so. If you didn't and a dealer forced reGen was required you and Director of Fleet maintenance have a talk about how you want to pay the bill.

there is a Regen initiation switch on the lower dash next to the inhibit switch. Fire apparatus are allowed to have a Regen inhibit to delay the Regen cycle in case the vehicle is not in an optimal conditions. Such as working a wild land fire where the High exhaust temps could have the possibility for starting an fire near the exhaust system. My operators use it to prolong the Regen so the next shift can do it. While the truck is in Regen inhibit mode it will not derate and the Regen light will reset until the truck is key cycled of and back on.I know that when the inhibit has activated 4 times a forced Regen will be required.
 
Worst case scenario, there are GM dealers every little ways between where you are and where you're headed. Heck one of 'em might even have the heater in stock and could install it for you while you wait!

I've only been a "diesel dreamer" not having enough reason to justify owning one, but I have studied the technology and read all the discussion forum threads. I sincerely doubt the truck will go into limp mode as long as it can get DEF when it needs to run a regen. Even then you have a grace period before it starts to really get cranky with the limp mode.

The truck doesn't run the heater when the engine isn't running, that would run the batteries down, so the DEF will freeze if it gets cold enough. The truck won't run a regen on a cold engine either, as I understand it. So by the time the engine's warmed up and (maybe) ready to start the regen, the DEF should be thawing from warmth in the engine bay. For sure the DEF will be thawed long before limp mode shuts you down to 5MPH.
 
Steve Butram":2ykuhywn said:
Rabbit Holler Flash":2ykuhywn said:
Steve don't that regeneration inhibit switch also have a start regeneration mode. First instruction we were given was if you inhibit regeneration you MUST start a cycle as soon as clear to do so. If you didn't and a dealer forced reGen was required you and Director of Fleet maintenance have a talk about how you want to pay the bill.

there is a Regen initiation switch on the lower dash next to the inhibit switch. Fire apparatus are allowed to have a Regen inhibit to delay the Regen cycle in case the vehicle is not in an optimal conditions. Such as working a wild land fire where the High exhaust temps could have the possibility for starting an fire near the exhaust system. My operators use it to prolong the Regen so the next shift can do it. While the truck is in Regen inhibit mode it will not derate and the Regen light will reset until the truck is key cycled of and back on.I know that when the inhibit has activated 4 times a forced Regen will be required.
Hmmm. Finger pointing between the shifts? Maybe you need a gadget attached to the switch that records a time stamp every time somebody hits the switch. I don't suppose the control module already does it?
 
Jim Becker":afjheyaz said:
Steve Butram":afjheyaz said:
Rabbit Holler Flash":afjheyaz said:
Steve don't that regeneration inhibit switch also have a start regeneration mode. First instruction we were given was if you inhibit regeneration you MUST start a cycle as soon as clear to do so. If you didn't and a dealer forced reGen was required you and Director of Fleet maintenance have a talk about how you want to pay the bill.

there is a Regen initiation switch on the lower dash next to the inhibit switch. Fire apparatus are allowed to have a Regen inhibit to delay the Regen cycle in case the vehicle is not in an optimal conditions. Such as working a wild land fire where the High exhaust temps could have the possibility for starting an fire near the exhaust system. My operators use it to prolong the Regen so the next shift can do it. While the truck is in Regen inhibit mode it will not derate and the Regen light will reset until the truck is key cycled of and back on.I know that when the inhibit has activated 4 times a forced Regen will be required.
Hmmm. Finger pointing between the shifts? Maybe you need a gadget attached to the switch that records a time stamp every time somebody hits the switch. I don't suppose the control module already does it?

There is Cummins Software that tracks that. But in the interest my own sanity I will not plug it in.
 
It's already on the ecm. They can print out down to time lights were turned on ,wipers activated ,brake application. Had dealer in Ohio show me hours I had used engine,"jake"brake since truck was built.
 
Matt Kirsch":29pph6fk said:
Worst case scenario, there are GM dealers every little ways between where you are and where you're headed. Heck one of 'em might even have the heater in stock and could install it for you while you wait!
GM has already put out the word to dealers nationwide in search of a dealer with one in stock. There are none to be found.

Matt Kirsch":29pph6fk said:
So by the time the engine's warmed up and (maybe) ready to start the regen, the DEF should be thawing from warmth in the engine bay.
The DEF tank is not in the engine bay, there for it will not heat without the heater.
 
Barnyard":270ohn0f said:
...........
The DEF tank is not in the engine bay, there for it will not heat without the heater.
If it's going to get cold maybe you can give it a hot water bottle and a blankie to sleep with :lol: or a nice heating pad :D
 
Scrivet":3k0oh4ze said:
Barnyard":3k0oh4ze said:
...........
The DEF tank is not in the engine bay, there for it will not heat without the heater.
If it's going to get cold maybe you can give it a hot water bottle and a blankie to sleep with :lol: or a nice heating pad :D
Fortunately, the extended forecast shows the temps will be cooperative. But, I'm glad to see you think like me. :lol:
 
Please don't say that, I've known Scrivet from the day Mom said we HAD to keep him. (I wanted a pony) and he thinks really spooky someties. :||): :||):
BTW guess who had to get a new Cat loader running with frozen DEF this week :shock:
 
Speaking of mom and cats guess who's 15 tomorrow?

OK, for everybody other than Rabbit Holler Flash it's our mother's cat MIndy. I always told mom that if she ever keeled over she had better land on that (insert Navy word here) cat because it was going in the casket with her. Well mom passed away seven years ago and didn't land on the (insert Navy word here) cat and I get to take care of her. My luck and she'll last another 15 years.
:big crying:

There were several people at mom's funeral who kept a close eye on me for some strange reason and I still get random calls from friends and relatives that start "So.... say.... how is Mindy doing?"
:big give up:
 
Back
Top