Yes you might if the price is right. I bought one used for cheap years ago, that's the only way I would have bought it. :-

:
They are marketed as a all in one do it fast and accurate package. That is a semi scam. They try to make the consumables (blades, sanding drums, ect.) proprietary so you have to keep coming back to them. You have to spend way more than you initially think to get enough accessories to get to critical mass where you can preform enough operations for all but the most basic project. A lot of planning is required to prevent wasting a ton of time on setup. New I would avoid them like someone infected by H1N1. However the concept is good for those very cramped for space. I have made some adapters to mount std. saws and sanding drums safely.
The bad:
Generally having to shift between modes is a pain because you loose your adjustments every time. There is no repeatability in any of the movements.
Saw table is small, hard to keep tuned, table tilts not blade (yikes), requires Special blades. A cheap "job site" saw is way better. I avoid miters on a table saw and use a miter saw for crosscuts.
Band saw is small (compared to the std 14") and uses a weird blade size. And its extra.
Sanding drum is not a standard size. Wont oscillate with out a accessory (another thing to buy)
The extension table for the crosscut guide is almost required for all but the smallest work pieces to keep from hurting your self.
The saw dust collection on the older ones (flat sheet metal saw cover) is awful and the later ones barely adequate.
A home made router table and a 100$ router is way better and vastly cheaper than any accessory SS makes to do the same. New Yankee has good plans.
The output shafts are plain stubs you set screw and female socket over. A MT collet system would have been so much better and is used by the rest of the machine tool world. Likely they wanted to avoid compatibility here and/or cheapness.
The good points:
The 12" sanding disk that works with the saw table mode is useful any where you don't have a inside curve, for that get a stand alone drum sander.
The best thing it does is a lathe. its big and rigid (ish) variable speed (but not as slow as a electronic drive). You can work off the end for doing large plates and bowls, but you will have to rig a rest.
The second best thing it does is a drill press. You can do the usual drill press things and the table is large. The head is not counter balanced so you better have it where you need it before you raise to press position.
It can rip saw large sheets if you have to with the small table on the on the end. I usually use a long straight edge and a hand held saw though.
I can edge drill large pieces but with plate joiners these days edge doweling is not they way to go.
There are a more accessory's to do this and that but I don't think any of them are a good bang for the buck.
If you can get one for less than and price of a drill press and the same size lathe at say Harbor Freight it may be worth it. You can always sell it to the Shop Smith faithful :roll: on ebay.
Mark