Depth Levrr

[DennisBufo]

Just picked this up. Can someone tell me if I have all needed to mount this and how to mount it? Pictures would be GREAT.
As always many thanks. I love this site.

 

[Barnyard]

It looks to be all there. The original I-bolt looks to have bee replaced with a standard I-bolt, but it will probably work. That is for the 189 two-way plow but it should work on 193.

Here is how a 189 hooks up.

 

[k hutchins]

For a single 193 plow you only need half of it. The half with the handle obviously. I don't know if the other half can be detached or not. If it can't you should still be ok. Hook it up per Barnyards picture, but you shouldn't need the drop down on the other side of the draw bar.

 

[k hutchins]

There is a downloadable instructions book for the 193 plow in the resources section. Go to resources at the top of the page and search 193 plow. It should give you all the info you need.

 

[DennisBufo]

Thanks a million. I believe I see how it mounts now. Will work on it this week. May be back for more help!

 

[Gary Dotson]

If you don’t already have them, you will need the tapered head implement attaching bolts, to mount it to the final drives. Also, the plow attaches to the #2 and #4 holes on the draw bar.

 

[DennisBufo]

If you don’t already have them, you will need the tapered head implement attaching bolts, to mount it to the final drives. Also, the plow attaches to the #2 and #4 holes on the draw bar.

Thanks for all the help. The long pipe does detach wich will make this an easier job.

 

[staninlowerAL]

Hi Dennis, I sent you a DM. Stan

 

[Glen]

Hi,
Below is the Cub 193 Plow owner's manual, it has lots of info, and shows how to put the plow on the Cub.
You don't use the manual lift lever to the left of the seat, shown in the manual on page 9, if the Cub has Touch Control.
Use the Rear Rockshaft Unit shown on page 10 if the Cub has Touch Control.
https://farmallcub.club/rudi/farmallcub.com/rudi_cub/www.cleancomputes.com/Cub/Cub Implement Manuals/Cub-193 Moldboard Plow 11-20-51/index.html

It says in the manual on page 8 to set the wheel spacing to the widths they say on the page.
There are front and rear wheel spacing diagrams in the Cub owner's and operator's manuals.

Below is a listing at TM Tractor Parts for the tapered head bolts, used to hold the drawbar, and some implements onto the Cub. You can look at the pictures. They also sell a 1 1/4" tapered head bolt.
The manual says the Depth Adjusting Lever uses the 1" long bolts to hold it on the final drive.

TM Tractor Parts for McCormick Farmall Cub, International Cub, and International Lo-Boy