concrete joint solutions

Rmankty

Active member
Hello, I live in Michigan. My Mother owns house Dad And Her Bought in 2005. I notice this fall in gaps between concrete sections of drive- sealant dropped down,so I pulled it out and in some places there were voids underneath. I bought bags of clean sand and filled,and let settled. I want to speed that up, does anyone know of better material/ technique than sand. I dont want to hire contractor if not necessary,I thought there was maybe a liquid filler to quickly go to void area and fill so I can put sealant on top. I have backer rod and DAP 3 hour sealant. Thanks for any help!
 
What size is the width of the crack and do you have an idea of the void size . Without that its is kind of hard to say. Possibly you could mix a very soupy slurry of sand and cement to pour down into the void if the size of cracks would permit. Good luck
:D

Edit. Once that is completed reseal with flex sealant to keep water from penetrating below the slab thru the crack.
 
The void didn't occur when the cement was poured. Something caused it. Most likely water moving under the slab(s).

Thinking you need to investigate how or what caused the void. Solve that problem first.
 
cracks in pavement and concrete can literally be bottomless pits and take vast amounts of sand or tar to fill when you get one that seems to never fill up take some rope and hammer it deep in to the crack and then top fill with sand or hot tar, I know that sounds cheesy but sometimes the hollow area under the slab is really big and there is no way to move the sand into all the empty spaces and with hot tar you can easily dump 3 gallons or more under a slab and that is rather costly.
 
Wash the sand into the void with water, a course sand works best. When it is full, let it dry, it will settle. Mix some portland with some more sand and wash it down the hole, the portland will cake up without the sand in it. the more cement you wash in the better. When it dries out, it will hold the sand in place.
 
Eugene has the correct idea. Concrete horizontally is either a slab covering a supporting subsurface or it is a bridge. If the subsurface is washing out or subsiding, the concrete is becoming a bridge. Cracks of 1/4" to 1/2" width can be filled with NP-1 by Sonolastic. But it is expensive.
 
I agree with the above posts specifically with using the sand and water approach. There is some underlying reason why the cracks are occurring, and I hope that you can find this. However, just pour sand down there will not fill the void completely, and it will only be a matter of time before you are doing the same thing. The water allows the sand to fill and mold into the void. It goes to show you how important prep and water control is to all structures! If you have a more expansive problem, you might consult a contractor. Angie's List can provide you with some options in your area.
 
It seem to me as if you pulled the expansion joint filler out. We used to use tarred joints in all cases. Later people started using Pressure treated 1" inch boards. NYC banned them after some started rising and causing trip hazards. Now in public walks you must use untarred strips and finish with a caulking from a caulking gun. It goes on plastic and then sets. The caulking is grey but I can't remember the name of it but it is special for that purpose.
I would use rope caulking packed in tight in your instance and finish with the caulking gun.
If your cracks are other than expansion joints I don't know what to offer with out seeing the cracks.
Got pictures?
 
Back
Top