BMW

I as wondering if any of you have had experience removing brake drums from a BMW. I am starting a Brake job on my 1984 318i, and getting the drums off looks like a big challenge. There is a set screw that holds the drum on it is a allen screw and both sides are stripped so far. I am sure the answer is a drill bit a easy out and some heat, just wondering if anybody has any other thoughts, or suggestions.
 
Hi Joe - A fellow Bimmerhead. You are not alone with that problem. I searched on google and found these quotes:

"Now, remove the brake drum. If you can't get the retainer
screw out, you're not alone. I had to drill it out. Keep working with a
wood block and a hammer on the outer edge and EVENTUALLY the drum will
seperate from the hub."

-and-

"The brake drum can be removed without the wood block and hammer if you
adjust the brake pads away from the drum using the adjusting wheel
located inside the drum, behind the hub. Rotate the drum and hub
until the adjusting wheel is visible through one of the lug bolt
holes. Working through the lug bolt hole, use a strong, slender,
standard screw driver to turn the adjusting wheel. Several turns of
the wheel should provide enough clearance to easily remove the drum"

I wish you the best of luck.
 
Wow what a pain in the You know what. After I attemted to drill out one side and broke a easy out in the screwI was ready to jump. So I stepped back and called on my friend Batty 54 he always bails me out or cleans up the mess I made. Well long story short he used a small cold chisel and a hammer to actually turn out the screw that I broke the easy off in next he did the same with the other side. Once I backed off the adjusters the drums came off. Now I can order parts but 1st I will drop off the drums to see if they can be turned.
 
Back
Top