Belt screams like a scared cat.

k9sicem

Well-known member
This is not Cub (or even tractor) related but I know someone on here can help me. When I put a 261 engine in my 39 Chevy 1/2 ton I also upgraded to a alternator. The belts scream at me when I give it gas. If I drive like an old lady it does not make a noise. I put on a new belt and the belt is tight. The alternator is new but I did not change any pulleys. What have I over looked? The belt noise is driving me nuts.

Here is a photo of the engine if it helps.

engine.jpg
 
Scott:

By any chance have you checked to see if the belts are too tight and placing excess stress on the pulley as in alignment? Reason I ask is I have been fighting the screaming belt/pulley problem in my 2000 DGC 3.0 for about 6 months. Finally, finally eliminated everything else and it now looks like the alternator pulley bearings are the culprit. Symptoms go away when spray lube is introduced but it is only temporary. Probably the solution is a new alternator, but I hesitate to go that route as the alternator is still working properly aside from the noisy bearing :roll:
 
Try getting the paint out of the pulleys, may be slipping on it. If I recall right the 261 had a 3/4 in belt and the alt may be a 3/8 or a 1/2 , you may need to put the old generator pulley on the alt.
It has been a coons age since I saw a 261.

Boss
 
As Rudi posted, the alternator bearings are suspect. As I recall, the 261 is a truck engine from the 50's. The crank pulley may be 1/2 wide. Adjust the valves about every 5000 miles.
 
Back
Top