Battery corrosion

Bus Driver

501 Club
As far as I know the 6 volt batteries still have fill caps. But many of the 12 volt do not. Sometimes the obvious must slap us upside the head to get our attention.
Battery terminal corrosion could be from a poor seal between the battery case and the projecting terminal. One fellow suggested that cleaning around that terminal and sealing it with it with RTV silicone will cure the problem. Sounds sensible to me. I have one that needs it.
 
First thought is; if it's a potential problem wouldn't the manufacturers be sealing them better than a person needing to glob on some RTV around the outside?
Second thought is; aren't there holes in the three cell caps? Exactly how would gases escaping these three holes know to not attack and corrode but the same gases escaping through the crack between the post and case know to cause corrosion?

My opinion is that battery corrosion is the nature of the beast. It's maintenance just like an oil change, a tuneup, or tire pressure. You're going to have to attend to it on occasion.
 
I seem to have had pretty good results cleaning the terminal and post, then spraying them down good with the red spray on battery protector from NAPA. Remember though, if you have a cutout and 4 position switch and leave the switch on high all the time, it will overcharge the battery causing fumes to come out the cap vents and that will accelerate the corroding.
 
corrosion on the terminals [and other connections]is a issue on the farm sense the horses were replaced
the cause of it is the air[oxidation of metal,, kinda like rust on steel]
if the air is blocked there is no oxidation

back in the day axle grease was coated on the terminals with fair results

now there is many products available to stop the oxidation

Mike
 
Back
Top