Wed Jul 13, 2005 1:00 pm
I am replacing the bendix of the starter on a Farmall H. I have removed the two long bolts from the back of the frame. However, when I try to slide the starter motor out of the frame, something seems to prevent the bendix and related washers from sliding out of the drive housing. Shouldn't they slide out freely? Do I need to tap on the front of the drive housing bushing? I need advice before I proceed further and possibly damage the unit. Thanks, Dan
Wed Jul 13, 2005 1:10 pm
If you are trying to remove the armature from the sarter, check for grooves on the commutator that the brushes may be catching in, or enven a spacer washer that is coming out with the armature instead of staying in the housing (brushes catching behind it).
Wed Jul 13, 2005 2:46 pm
Thanks, John. I now have the starter motor and bendix out of the housing. Now to exchange the bendix between the good starter and a parts one. The bendix in the good starter has two problems: There has been so much wear against the ring gear that 50% of the ridges on the bendix are gone. Also, the bendix is locked in place. Even when I try to turn in by hand it does not rotate forward. If I loosen the two bolts on the motor drive can I slip the motor drive and all parts in front of it off of one starter and replace it with the equivalent good unit from the parts starter. Thanks, Dan
Wed Jul 13, 2005 6:16 pm
Got the starter cleaned up and changed out the bendix. It seemed to function properly when I tested it. Will install in tractor tomorrow and see if it really will work. Also, cleaned up the coil. Will install it tomorrow and , if the coil functions, I think the H will start and run. It has been a couple of years since it ran. Thanks for the instructions and advice. Dan
Wed Jul 13, 2005 8:21 pm
Donny: I will let you know of the result. I have my fingers crossed. If the coil functions I believe it will run. I received your new phone numbers. Thanks, Dan
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.