Fri Apr 30, 2010 10:43 pm
I have a 154 loboy & I have the clutch out but I also want to inspect the clutch brake pads while i'm in there. I have an I&T shop manual & the 154 owners manual but they havent helped. I can't figure out how to: either remove the rear flywheel or the clutch brake arm to give enough clearance to slide the pucks back & up. Any help is appreciated!
Sat May 01, 2010 2:33 pm
If you look down at the transmission, there's a plate that runs across the front, behind the clutch. One large, short bolt on each side secures it to the transmission. Take the rod loose from the clutch brake bracket, then remove the large bolts, and you can slide the entire clutch brake bracket up and out of the machine.
Sun May 02, 2010 10:23 am
Also Ed, you slide the brake buttons FORWARD (not backwards) and up
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.