Sun Jan 27, 2013 4:38 am
Need to repair my shifter and found this link by searching the forumhttp://www.cleancomputes.com/Cub/Mainte ... vement.htm
Anyone know where to get the offset washers used to do this repair? Any idea on specific sizes? Please help! Thanks....
Sun Jan 27, 2013 7:03 am
I don't know where George got those offset washers, you might check McMaster Carr and see if they have anything like them. George was quite the machinist so he may have made them.
Sun Jan 27, 2013 8:14 am
If I can remember George told me he went to a local auto parts store and bought Dorman - Mag Wheel Washers. The last one I did the only ones I could find is Offset - I.D. 0.70 Inch O.D. 1.25 Inch. Probably a good hardware store or McMaster-Carr if the auto parts store doesn’t have anything.
Sun Jan 27, 2013 10:33 am
I had an interest in doing this but finding the washers and machining the parts put this way on the back burner. I see one offset washer from Dorman (for Cragars) but not two. Mcmaster has nothing of the sort. I always thought this would make a nice kit to package.
Sun Jan 27, 2013 11:57 am
Below the second picture he said:
I decided to make new retainers and . . .
I don't think George ever hesitated to make a part if he thought he could make one that would work better than the original. I think you can do a pretty good job of keeping water out using the original parts and replacing/adding an o-ring.
Sun Jan 27, 2013 2:19 pm
Fastenal has beveled and hillside washers.
Disclaimer I own stock in Fastenal
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.