grader blade question

Sat Nov 24, 2012 11:06 am

Hi all, I have a model 54 snowplow/grader blade that is missing the round rod that goes from the rockshaft down to pivot arm, would some one have one that they could measure the lenght so I can make one?, you can see the round rod in this picture from TM tractor
thanks Tim
You do not have the required permissions to view the files attached to this post.

Re: grader blade question

Sat Nov 24, 2012 12:20 pm

Tim...does this help?
http://farmallcub.com/phpBB2/viewtopic.php?f=1&t=17896

Re: grader blade question

Sat Nov 24, 2012 1:38 pm

tst wrote:Hi all, I have a model 54 snowplow/grader blade that is missing the round rod that goes from the rockshaft down to pivot arm, would some one have one that they could measure the lenght so I can make one?, you can see the round rod in this picture from TM tractor
thanks Tim


Tim, I just measured mine, it is 23 inches center to center.

Bruce T.

Re: grader blade question

Sat Nov 24, 2012 1:51 pm

Winfield Dave wrote:Tim...does this help?
http://farmallcub.com/phpBB2/viewtopic.php?f=1&t=17896


That's excellent! First time I've seen it.

Re: grader blade question

Sat Nov 24, 2012 4:40 pm

Thanks guys for the help
Tim

Re: grader blade question

Sat Nov 24, 2012 8:36 pm

If function before fashion isn't a problem, and you plan on doing more grading work than snow removal, you may want to add a 1" piece of angle iron down the length of the rod to reinforce it from bending.
You do not have the required permissions to view the files attached to this post.