Farmall Cub

by **JackF** » Fri Nov 23, 2012 8:31 am

What I could remember the first ’55 Cub Lo-Boys’ had the regular finder on it and it was changed after complaints..so I say 1955 International Cub Lo-Boy

by **Boss Hog** » Fri Nov 23, 2012 8:36 am

I never said I knew the answer

but it is in square nose years

by **JackF** » Fri Nov 23, 2012 8:52 am

1965 International Cub Lo-Boy ...they cut out more of the lower part of the finder

by **Boss Hog** » Fri Nov 23, 2012 9:11 am

by **Paul Wells** » Fri Nov 23, 2012 5:48 pm

Was the platform shorten on a low boy, or is the final drive rotated over and to the front, causing the need for the fender to be shorten as well? I have more foot room in front of the fender on a standard cub.

by **Boss Hog** » Fri Nov 23, 2012 6:20 pm

The floor board is the same, just took them almost 10 years to figure out that it needed to be cut off

by **Paul Wells** » Fri Nov 23, 2012 6:50 pm

I guess part of my question is when they lowered it did that cause the final drive and fender to be shifted to the front> I have not looked at a low boy up close, but could see that pushing the fender forward almost to the front edge of the platform. Just curious.

by **Barnyard** » Fri Nov 23, 2012 7:19 pm

Paul, yes, they rotated the LoBoy finals forward in order to lower the Cub.

by **Jim Becker** » Fri Nov 23, 2012 9:27 pm

How many of the cut off fenders have you run into? My '66 (less than 4,000 from the last built) has a full length fender on the right side.

by **Former Member** » Fri Nov 23, 2012 9:29 pm

wellsknob wrote:I guess part of my question is when they lowered it did that cause the final drive and fender to be shifted to the front> I have not looked at a low boy up close, but could see that pushing the fender forward almost to the front edge of the platform. Just curious.

Approximately 8"

by **Boss Hog** » Fri Nov 23, 2012 9:49 pm

Jim Becker wrote:How many of the cut off fenders have you run into? My '66 (less than 4,000 from the last built) has a full length fender on the right side.

3 and I have only had 5 lo boys one of them was a round nose I think it was only in the last 2 years and a very few late 66s
Dale do you have a pic of that lo boy you had?

by **Boss Hog** » Fri Nov 23, 2012 9:51 pm

It is in my last parts book

by **Paul Wells** » Fri Nov 23, 2012 9:54 pm

Thanks Bill, and Dale,
So that would mean the wheelbase on a lowboy would be about 8" shorter than a standard Cub.

by **Barnyard** » Fri Nov 23, 2012 10:13 pm

My 65 and 66 LoBoys have the standard fender on them.

Farmall Cub

trivia question

Re: trivia question

Share On:

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Re: trivia question

Who is online