Mon Nov 12, 2012 8:55 pm
is there a grease fitting on the clutch release bearing like a cub has inside the hand hole cover?
Mon Nov 12, 2012 9:19 pm
Tue Nov 13, 2012 7:29 pm
There is a grease fitting on mine, you access it through the small hole on the left side of the clutch housing but not through the hand hole cover.
I assume it is the throwout bearing
Tue Nov 13, 2012 10:38 pm
On a 140 it only greases the the input housing shaft where the throw out bearing slides on not the bearings.
Correct me if I'm wrong.
Tue Nov 13, 2012 10:41 pm
you are correct, the bearing is sealed
Thu Nov 15, 2012 6:34 am
AAAAAAAHHHHHHHHHHHH, Grasshopper learn.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.