FEL , Super A

T

TWheat

Well-known member
Got it working pretty good, but taken before additional reservoir added. Thanks to Jim Becker for advice & suggestions.
 

Attachments

  • sa-loader-22.JPG
    sa-loader-22.JPG
    193.4 KB · Views: 1,197
  • sa-loader-21.JPG
    sa-loader-21.JPG
    202.2 KB · Views: 1,197
Thanks,
It is a modified loader made by Brantley Mfg. Co . of Frederick, OK. The hoses were shot, but no welds and the clyinders were good. This is what it looked like "before"
 

Attachments

  • sa-loader-1.JPG
    sa-loader-1.JPG
    140.5 KB · Views: 1,125
Looks great but just a suggestion... More bracing.

Right now that is putting almost all the force on the bell housing. I would run braces from the tops of the towers down to the front cultivator mount at least, and maybe two more from the tops of the towers down to the finals. The low braces are a good start but frankly it needs more.
 
Thanks Matt, something to think about. It doesn't do a lot of work, in fact the relief bypass settingis pretty low right now, just haven't gotten into setting the pressure up some.
 
You must log in or register to reply here.
Back
Top