Needle valves and seats to the Bash

Tue May 22, 2012 6:44 pm

I was measuring some old ones this afternoon. To my surprise, I found three different ID's on the seats, and two OD's on the needles. Enough difference that they are not interchangeable. If you have some old ones and are attending the Bash, please bring them so I can measure them. It may not clarify anything, but I've been in a state of confusion most of my life anyway. :lol:

Bob

Re: Needle valves and seats to the Bash

Tue May 22, 2012 6:50 pm

Bob McCarty wrote:but I've been in a state of confusion most of my life anyway.

Bob

So that's why I am still finding things you hid at the bash last year! :shock:

Re: Needle valves and seats to the Bash

Tue May 22, 2012 7:20 pm

I will try to round up some

Re: Needle valves and seats to the Bash

Tue May 22, 2012 8:04 pm

Barnyard wrote:
Bob McCarty wrote:but I've been in a state of confusion most of my life anyway.

Bob

So that's why I am still finding things you hid at the bash last year! :shock:


All of us that have hosted a Fest have a special appreciation for this statement. :lol: :lol:

Re: Needle valves and seats to the Bash

Wed May 23, 2012 6:11 am

Bob, I have a new one from a TSC kit that has a viton tip, if it will do you any good. (After reading the comments about them, I re-used the old one) Can't explain why I kept it.. Just did..
Regards,

Re: Needle valves and seats to the Bash

Wed May 23, 2012 8:38 am

sdurnal wrote:Bob, I have a new one from a TSC kit that has a viton tip, if it will do you any good. (After reading the comments about them, I re-used the old one) Can't explain why I kept it.. Just did..
Regards,

In case you needed it later..............if you can find it. :shock: :lol:

Re: Needle valves and seats to the Bash

Wed May 23, 2012 10:17 am

Me thinks you speak from experience, Denny! hehe cya soon..