Sat Jul 02, 2011 1:12 pm
Does anyone have the head bolt torque sequence for a Farmall MD? I looked all through the service and operators manuals but it is not listed anywhere.
It gives the torque spec as 110 ft. lbs. but that is it.
Or do I just start in the middle and work out in a circular pattern in multiple steps?
Thanks in advance for any help.
Wed Jul 06, 2011 8:49 pm
Start in th middle and work out , i set the torque at 30 torque all the keep going up that way you keep thepressure constant alll over going up 20 to 30 each passtoo reach the specified torque.
hope this helps
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.