42 H transmission

Thu Jun 09, 2011 7:15 am

Recently aquired a 42 H
fourth gear has 2 broke teeth on counter shaft
have the to sliding gears out need to get the lower countershaft out have it loose bearings out etc , book says to lift right out, with the large gear in place it will not come out of the tranny.
anybody been that far into the tranny , to help
I know the gears are pressed and keyed , appears I will have to pull the front gear, any help would be appreciated


Re: 42 H transmission

Thu Jun 09, 2011 11:13 am

I will be no help on this Phil.Mine works great at the moment and I hope it stays that way.Much differnt than your M??? Good luck.Kevin :shock: :shock:

Re: 42 H transmission

Thu Jun 09, 2011 12:38 pm

I talked to Tina Hines at Hines Equipment in Delta Ohio
She said it does come out as one unit , minus the bearings , it is just takes some patience.
IHC was ahead of the times , the puzzles that will only come apart one way , the horseshoes and chain, 2 bent nail things ,chinese puzzle boxes,etc. :lol:

Re: 42 H transmission

Sat Jun 11, 2011 10:31 pm

Got the counter shaft out, found that the front gear was to far forward had to be tapped back on shaft ,came right out.
as a complete assy