Restored Little Genius with latest 1942 H Distillate

[Phillip W. Lenke]

Just aquired a non running 42 H , little tlc and runs klike a champ, have some shifter difficulties , keeps loosing sequence and locks up , have to keep taking shifter out and setting back to neutral,
Will deal with the tranny later. but plowed with our restored plow, worked Great!
Now the plow goes in storage till fall plow days , Sept in our area.
Phil




Before






1942 H Distallite and Restored Plow

[OliverFarmall]

That's a nice job !

[Mr E]

Awesome !!! I love it.

[John *.?-!.* cub owner]

Looks good PHil, and sure brings back some memories, though ours never looked that nice. We pretty well wore ours out over the years, It rolled enough ground that the trail wheel wore out on the side to the point that the rim nearly came off. I was working at the local hospital at the time and dug around in our junk pile and found a worn sprocket wheel off a clothes dryer that was just the right size to weld to the back. The sprocket teeth stuck out just a little and it left a funny trail behind it, but it worked. We learned that when plowing several hours a day with a narrow front tractor, that if you put a tire one size smaller on the right front than on the left it takes a lot of strain off your arms holding the steering wheel.

One word of caution if you are not familiar with trip plows, once they are a little worn, they will drop just when pulling the rope, it does not always have to be moving. It is a good idea at a show to raise the levers so the bottoms are on the ground to prevent meddlers from dropping the bottoms on someones foot.

If you are pulling the rope to raise it when it strikes a rock and tips the break away, you would be amazed how long your arm will stretch before you realize you need to turn loose of the rope.

[Phillip W. Lenke]

John
I found out about the trip hitch , I had this plow competely apart , the spring tripped on me , heard a load snap and looked behind and there she sat, a couple turns on the bolt and she held . I know not to tighten to much , it has to trip if it hits something that will damage the plow, I took severals advice to keep the line loose on the plow , for that reason alone,
It took three plows to make one good one , with spare parts salvaged, with scrap prices being what they are and the extra parts I sold I ended up with this one free and clear , apart from the paint.
It is an exceptional plow now, Will be taking it to our County fair to display behind our restored M
Phil

[Rodney51Cub]

[quote="Phillip W. Lenke"]Just aquired a non running 42 H , little tlc and runs klike a champ, have some shifter difficulties , keeps loosing sequence and locks up , have to keep taking shifter out and setting back to neutral.

Might check the ball end of the shifter that fits into the shift forks for wear. Worked on one that would come out of the shift fork and try go into another because the ball was worn. Had to build up the ball with a welder and then grind down to fit.

[Phillip W. Lenke]

Thanks
That is what I have seen as well there is also a noise in 4th gear like gear hitting
Not sure what that is will have to take the top off to investigate
Phil

[Bill Hudson]

Phil,

The plow looks great and I'm confident the H will look as well, soon.

Bill

[Rabbit Holler Flash]

So thats why that plow had the tooth drive furrow wheel. I pulled that rig some for your dad n now " I know the rest of the story "

[tinnerjohn]

One word of caution if you are not familiar with trip plows, once they are a little worn, they will drop just when pulling the rope, it does not always have to be moving. It is a good idea at a show to raise the levers so the bottoms are on the ground to prevent meddlers from dropping the bottoms on someones foot.

If you are pulling the rope to raise it when it strikes a rock and tips the break away, you would be amazed how long your arm will stretch before you realize you need to turn loose of the rope.

Maybe this should be in the safety forum. My son lost the end of a finger when that happened and the baler twine he had tied on the trip degloved it. Also, DO NOT tie the trip rope to the seat, use a piece of fence wire or coat hanger as an S-hook to hook it over. The seat spring can launch you pretty quick when the rope finally breaks. Don't ask how I know. John

[v w]

Have plowed with a 39H that originally burned distalite but not by the time I drove it. M&W pistons and sleeves increased the compression. Did the little genius come on rubber? I thought that is what dad called the plow. Both the 2 bottom and the three bottom were on rubber. With the distallite tractors I have seen at shows only one still had the shutters. My understanding is that is a hard part to find. Vern

[John *.?-!.* cub owner]

Later mode Little Genius plows came on rubber, but the early ones were on steel.

[RaymondDurban]

The '45 H that I have that was bought new by my grandfather still has the shutters and all the linkages. Of course he removed the shutters years ago and put them in the barn, so they are in near new condition.