This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
100 wiring question
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- Pony Master
- 10+ Years
- Posts: 3032
- Joined: Thu Nov 15, 2007 10:39 am
- Zip Code: 62253
- Circle of Safety: Y
- Location: IL, Greenville
100 wiring question
After getting the 100 running real nice I thought I was going to move on to the hydraulic lift, but after a few trial runs I noticed the battery seems to always be low. I put the meter on it, and no charge. First thing I decided to do is to clean the connections. Some were pretty bad, so I have to stop and pick up some properly sized ring terminals on my way to work. Then I noticed there was a ring terminal on the terminal on the rear of the Voltage Regulator, but no wire. After looking through a couple of my other manuals (no manual for a 100 yet) I am under the impression that it should be a ground. Is that the case? If not, what color of wire goes there? I have an extra aqua-greenish-blueish- wire that seems to go nowhere, I assume it goes to my non functioning headlights?
1947 Circle Cub, 193, 189
1954 Cub w/FH, IH100, 194, F11
1956 Cub Loboy w/FH and 194
1960 Cub Loboy w/FH and L-54
1953 Super A, 2 seater B, Avery V, Avery A, JD M, MH Pony, Leader D, Allis Chalmers C, and my Great Grandpa's ZA Minneapolis Moline.
1954 Cub w/FH, IH100, 194, F11
1956 Cub Loboy w/FH and 194
1960 Cub Loboy w/FH and L-54
1953 Super A, 2 seater B, Avery V, Avery A, JD M, MH Pony, Leader D, Allis Chalmers C, and my Great Grandpa's ZA Minneapolis Moline.
-
- Team Cub Mentor
- Posts: 20370
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Re: 100 wiring question
What is the letter under the regulator terminal? If the leter is an "L", not a ground.
http://www.cngco.com/
Go to Cub Cadet, Parts look up. There is a wiring diagram the 102.
http://www.cngco.com/
Go to Cub Cadet, Parts look up. There is a wiring diagram the 102.
I have an excuse. CRS.
-
- 10+ Years
- Posts: 2338
- Joined: Sat Apr 10, 2004 6:12 pm
- Zip Code: 40218
- Circle of Safety: Y
- Location: KY, Louisville
Re: 100 wiring question
If the 100 has the correct voltage regulator on it, that terminal is for the GEN. One side of the VR should have F or FLD, Bat, and L or Load. The other side or bottom should had a Gen terminal, and that bluish/greenish wire connects to that terminal and the other end connects to starter/generator "A" terminal.. The correct VR is grounded thru the VR mounts and does not have a ground terminal. The wire colors are:
VR Gen to generator A, Light blue
Generator A to starter button, Red
VR "F" to generator F, Yellow
VR Bat to stsrter button, Gray
VR "L" to ignition switch, Light Green
Ignition Sw to coil +, Black
Coil - to points, Black
Condenser to coil -.
Some other VR's do have a bottom side GRN or Ground terminal, but those do not have a "L" terminal.
VR Gen to generator A, Light blue
Generator A to starter button, Red
VR "F" to generator F, Yellow
VR Bat to stsrter button, Gray
VR "L" to ignition switch, Light Green
Ignition Sw to coil +, Black
Coil - to points, Black
Condenser to coil -.
Some other VR's do have a bottom side GRN or Ground terminal, but those do not have a "L" terminal.
-
- Team Cub Mentor
- Posts: 20370
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
Re: 100 wiring question
I have an excuse. CRS.
Who is online
Users browsing this forum: No registered users and 4 guests