Finally got the tc valve reassembled last Saturday. It was not too bad. The only problem was the main connecting rod was rusted tight to the piston and needed to be pressed off at the machine shop. After that was done it only took about an hour. There were three old rubber boots smashed down inside the piston, so this isn't the first time for this valve.
I would have been pretty lost without the directions that Tom (TMTractor Parts) sent me with my parts order. Here is the manual. It describes the steps better than I could.
Will it work ?
I'll let you know after I reinstall it and rebuild the pump.
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Touch Control Rebuild
-
- Cub Pro
- Posts: 1952
- Joined: Tue Mar 11, 2003 9:16 pm
- Zip Code: 85615
- Tractors Owned: 6 Cubs and no mas.
1947 Circle series Farmall Cub with Armstrong lift, belt pulley, 5"rims 6" tires, SN 563
1949 Farmall Cub with high crop option and hydraulics
1955 Farmall Cub with fast hitch
1955 International Cub Loboy with fast hitch
1957 Farmall Cub with fast hitch
1959 Farmall Cub with fast hitch - Location: way high up in the Huachuca Mt. at the bottom of a deep dark canyon
Touch Control Rebuild
"The time you spend making sure you are safe is probably the most productive time you can spend!"
George Willer
George Willer
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5
- 258
-
by Dale Finch
Tue Jul 18, 2023 9:32 pm
-
-
Should this be used with touch control Attachment(s)
by cowridermi » Sun May 14, 2023 2:41 pm » in Farmall Cub - 2
- 236
-
by radioguy41
Sun May 14, 2023 5:07 pm
-
-
- 4
- 272
-
by Bill V in Md
Thu Feb 10, 2022 9:55 pm
-
- 2
- 290
-
by tst
Wed Nov 17, 2021 1:16 pm
-
- 5
- 1113
-
by Glen
Thu Dec 28, 2023 6:35 pm
Return to “Engine, Clutch, Transmission and Hydraulics”
Who is online
Users browsing this forum: No registered users and 0 guests