This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
SCARED! To take Governor Off
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 341
- Joined: Wed Nov 08, 2006 9:35 pm
- Location: Backswamp North Carolina
- Contact:
SCARED! To take Governor Off
It has now come to the part in my restoration to replace all the front seals on the engine. But I am not sure how to remove and replace the Governor without messing timing up. I have seen it on here before but cannot find the thread. Can some one break it down step by step. On how to take it off and put back without messing timing up.
1961 Cub
1948 Cub
1960 CUB
1964 CUB CADET 100
23A Disc,2-C-22 sickles,54 Blade,152 disc,38a lift disc,C2 Mower,Kub Klipper, and a side dresser.
1948 Cub
1960 CUB
1964 CUB CADET 100
23A Disc,2-C-22 sickles,54 Blade,152 disc,38a lift disc,C2 Mower,Kub Klipper, and a side dresser.
-
- 10+ Years
- Posts: 2707
- Joined: Wed Oct 12, 2005 8:28 am
- Zip Code: 48463
- Tractors Owned: 1956 FAST HITCH CUB
MODEL 10 CUB TRAILER
2 1950 Demonstrators - Location: MICHIGAN, OTISVILLE
-
- 10+ Years
- Posts: 1841
- Joined: Sat Nov 06, 2004 2:28 pm
- Zip Code: 43130
- eBay ID: evilboweviel
- Location: OH, Lancaster
- Bigdog
- Team Cub Mentor
- Posts: 24144
- Joined: Sun Feb 02, 2003 12:50 pm
- Zip Code: 43113
- Circle of Safety: Y
- Location: OH, Circleville
- Contact:
As Ron said - set the engine with #1 cylinder at TDC on compression and be sure it does not move while the governor is off. It will then be easy to replace the governor properly timed to the engine.
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
-
- 10+ Years
If you have not removed the governor just yet, remove the drive seal first. Then with number 1 cylinder at TDC you can use nail polish to mark the timing gears.
There are punch marks on the gears but hard to see (tired eyes ). On reassembly install the governor per the marks and put the new seal in after the governor is installed.
There are punch marks on the gears but hard to see (tired eyes ). On reassembly install the governor per the marks and put the new seal in after the governor is installed.
Who is online
Users browsing this forum: No registered users and 10 guests