rolling harrow

Wed Apr 02, 2014 4:32 pm

Having trouble greasing the zerks on my rolling harrow. Have just a small slot there and the grease gun end is too long to fit squarely on so I got a 45 end and a button end but both were too fat for the slot. Any ideas?

Re: rolling harrow

Wed Apr 02, 2014 7:22 pm

Look up grease gun tips. There are several configurations that are very thin and will grease zerks, recessed or enclosed in a confined space.

I have one that works on universal joints. Basically this gun tip depresses the ball in the zerk and then you can grease the u-joint.

Available at auto parts stores.

Re: rolling harrow

Wed Apr 02, 2014 9:39 pm

try one of these. The point will push the check bal back and the outer taper will fit against the inside of the fitting to allow squirting grease inside. a note for the guys that have the cubs with the early throwout that are hard to grease, these work great.

Image