All non-Cub/Cadet/IH/Farmall/Case tractor and machinery discussions.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
5 posts • Page 1 of 1
I’m about to buy 60 head of new cattle. So, I’ve got to expand my pasture very quickly. I have to dig several postholes for multiple gates/entryways. I’ve use the Pengo Aggressor auger bits for years, but the bit is wearing down too fast...the dirt is hard due to lack of rain. Anyway, someone told me to switch my dirt auger bit to a rock auger teeth. Has anyone tried this before? Are there any good videos on how to change the auger bit teeth?
I have never had much experience with the tractor augers, about all the posts I ever put in were done by hand, though it has been several years. i do know that in this area due to the make up of clay and rock they do use special bits if they plan to do much, but I do not know what kind they are.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
Once upon time, when my back was strong, I dug postholes the old fashion way too. Now, my tractor and auger digger can do a heck of a lot more work than me.....only if I can keep the dang auger teeth sharp!
Most of the time around here, my 3 point hitch digger digs very well. If you feed it too fast in the spring when the ground has a lot of moisture in it, the auger will screw itself into the ground. Not good!.........Then you have to take a large pipe wrench with a long pipe for leverage and screw it back out of the ground. On the other hand, when it has been dry for a long time, the auger will not dig at all. Then we dig as deep as we can, pour a bucket of water in the hole and wait a day. Then it digs ok.
1947 Cub S/N 9216 (My Dad's "Uncle Bob")
We make a living by what we get, but we make a life by what we give......Winston Churchill
I'm not familiar with that brand but I do have some knowledge from working with caisson rigs for years. Really only two things control the way an auger digs. First is the cutting edge. The best hardened steel is the most expensive. Simple as that. The second thing is how much pressure is put on the auger. That's the skill of the operator. We used water to lubricate the bits and to polish the sides of the bore. I doubt it did anything to soften the soil. Raise the auger often to shake off the cut soil that makes everything run smoother.
47 Cub (Glenda)
52 Super A
62 Cub (Genie)
In all things know which way the wind is blowing.
5 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests