Farmall Cub

Thanks to all that answered my question on Woods Dixie Cutter.Found out manuals are available but you need serial number. Went to woods dealer and he recomended leaving gear box alone but replace grease with Ep 90.
Now I bought a 6 foot pull type bush hog. It is missing half of the driveshaft. The driveshaft from gear box is intact. The tongue measures 39 inches. So I figure I need a 5 foot shaft. I was told this will wobble and will need bearing. Someone else said I need a 3 part shaft. Does anyone have any idea how shaft should be set up? Also will turming put too much stress on universals with shaft of that link?

Do you plan to pull the 6 footer with a cub?

Bill

I do not think that would work. I have a MF 165.

Boy am i glad to hear that. I missed that you were in the other tractors and machinery forum. I have a 6 footer on a JD 1050. I felt foolish when i read your reply. Yet the only stupid question is the one you think of and don't ask.
Alittle foolish is good for me from time to time. It brings me back to earth.

Bill

I have an old IH rotary mower (bush hog), pull type. The PTO has a carrier bearing located near the front edge of the mower deck and at the same height as the gear box. The carrier bearing mounts between two bars (braces) that attach to the front of the mower deck. The PTO is one piece from the carrier bearing to the gear box. The front shaft has two parts, one sliding inside the other with the outer end attaching to the tractor's pto shaft. There are three U-joints in this PTO shaft. One at the tractor, one directly in front of the carrier bearing and one at end nearest the gear box.

Turning. Even with the three part PTO shaft I can not make a real tight turn with out binding the PTO shaft.

OH. I have managed to mess up the PTO shaft twice. $150.00 a shot to straighten and repair. First time I had to replace the U-joints and one of the yokes broke - just old age. The second time the drawbar pin fell out - PTO shaft separated - wap - bent that sucker in half.

Ain't farming fun.

You really need to figure out exactly what you have, and how it's supposed to be set up. Maybe it has a carrier bearing in the middle... Maybe it doesn't... That's why you ended up with three different, conflicting, pieces of advice.

Carefully look over the mower. Does it look like there was a bracket bolted to it near the front of the mower, or on the tongue, in the past?

Thanks to all. It is reassuring to know that there are people who take time and enjoy helping . I am begining to think my wife was right, she is yelling that I should have bought new and not mess with old junk. I tried to explain that it is fun to fix up things but I am having my doubts.
There is a H bracket on tongue this must have been for carrier bearing
and I am thinking shaft must have had 3 universals. But I am having trouble picturing this. If anyone has a picture of this set up or similar I would appreciate it.

I don't know what brand this is but it should be similar. The telescoping part of the shaft is behind the carrier on this one.

Thanks. Telescoping part will be behind carrier on mine to. That is a big help. No safety on this type of shaft I guess.