All non-Cub/Cadet/IH/Farmall/Case tractor and machinery discussions.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
8 posts • Page 1 of 1
I bought a 1971 Hobart welder, G-213, with a Wisconsin TJD 2 cyl engine. The "runs good, welds good" was not exactly true but I got it running and welding but still needs some carb work. It has 2 speeds, 1800 for welding and 2200 rpm for use as a generator. The throttle knob is a T shaped handle connected to a small chain that goes to the govenor linkage. There is no lock of any form that I can see. I am not sure how to lock it at either of the two speeds. The parts diagram does not show that area clear enough for me to tell if I am missing a throttle lock. Anyone familiar with these welders than can tell me what I may be missing?
I turned the handle thinking it would lock but it did not. I took apart the handle looking for any notches or locks and there are none. This may not be the original throttle control and I may have to file some notches into the hadle shaft.
Is the hole the handle comes through key-hole shaped, so the handle can be pulled out and locked in the notch?
Tractors are made to work!
"A Cub will do as much as a team of horses,.. More in hot weather!" - C. W. Spradlin 1909-1994
TJD Wisconsin manual shows two speed controls: 1) TT-66 variable speed governor control assembly and 2) TT-66-F Idle control assembly.
TT-66F: Shows a knob which is lifted, moving a rod out of a slot on the back of the tappet cover. Engine speed set, then the knob lower - moving the rod into the slot.
TT66: Is the one with the small chain. It appears to function like the old manual choke controls. Pull/push only. I'm looking at the parts photo. There appears to be a nut on the back side that may control the tension on the shaft.
Starting procedure - simply states to set the throttle position in 1/2 open position. Doesn't explain further.
I have an excuse. CRS.
Are you sure 2200 rpm is for the generator? That would be a very unusual speed. Normally they are 1800 or 3600.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
We had one of those welders where I used to work. Pull the throttle and twist the t-handle to the right to lock. I don't think there were any notches or such, just a friction lock, which may be adjustable. It could be locked in any desired throttle position.
Thanks for the replies. I expect the lock is just missing. Likely I will just drill a few holes in the throttle knob shaft and place a pin to set the correct distance.
The generator does run at 1800 rpm and 2200 for the welder. I had it backwards.
8 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest